Pack Of 10, 8w LED Fire Rated Downlight, Matt Black Bezel

Sometimes, the light colour you see online or in-store may not translate as perfect in your home. It’s understandable if you want to change it. However, if you don’t have anywhere else to use that fixture, you’ll end up wasting your money and going back and forth in-store or waiting for the delivery of your fitting may delay your build or renovation.

Fortunately, this LED downlight can solve that problem! You see, it’s colour adjustable; therefore, you get cool, natural and warm white light in one fixture! There’s a small toggle switch on the side of the downlight. So, if you think cool white does not suit the space or warm white makes the room too yellow, you can easily switch!

Typically, if you’re tight on your renovation budget, you’ll opt to DIY most of the build. However, complicated installations are not DIY-friendly and would require more time, effort and human resources. Fortunately, you don’t need to look far and wide to find a lighting unit that you can install in a breeze. As long as you have the right tools, knowledge and experience, you won’t have any issues!

This LED downlight is designed with a push-fit terminal for easy loop in/out, twist and lock bezel, and insulation coverable clip and fit drivers. Also, it’s mains powered, so you don’t need to get a separate driver to make it work!

Before installing lighting fixtures in your bathroom or outside your home, you need to guarantee that it’s water-resistant. How will you know this? Look at the IP rating! If a fixture is IP20 rated only, you can only use it indoors except in the bathroom. It’s not waterproof, so keeping it near water sources is dangerous. So, if you want a fixture you can mount anywhere, this LED downlight is the one you should get!

It’s IP65 rated, so even in your bathroom’s zone, it’s okay to install. This fitting will not get damaged even if jets and splashes of water come into contact with it. Just don’t submerge it underwater because it’s not waterproof enough to survive. If that’s the application you’re after, an even higher IP rating is required!

While it’s essential to get adequate illumination, it does not mean that you should not think about the electricity bill you’ll receive monthly. However, that does not mean you can only use the bare minimum! The way to go about this is by using energy-efficient lighting solutions like this LED downlight!

At only a minimal 8w of power, this fitting can produce 900 lumens maximum brightness! If you compare it with other non-LED fixtures, you won’t be able to find one that comes near this energy-to-light conversion. In addition, it has a long average lifespan of 30,000 hours, therefore, not only lowering your electricity expenses but also decreasing your maintenance cost!

Dimmable lights can make a remarkable difference to the overall look of a room. If you haven’t tried one, you can start with this LED downlight! Since it’s already colour adjustable, you can further enhance the ambience of your space by dimming or brightening it depending on what you’re doing!

This LED downlight is trailing or leading-edge dimmable, and we performed extensive testing to ensure broad compatibility. Although it will likely work well on other LED dimmer models, which are not included in our list of recommended dimmers, we cannot fully guarantee the compatibility of any dimmer models not listed in the recommendations. So, to make sure you won’t waste any money, it’s best to follow this suggestion.

When you cut a hole in your ceiling, its fire integrity gets compromised. If left open, in case a fire breaks out, it can travel through the hole and spread quickly to your ceiling and walls. While recessed downlights can fill the gap, they cannot fully reseal it. Only a fire-rated downlight like this can help you address this!

Fire-rated downlights are made with an intumescent pad that expands when exposed to a specific temperature. Because of this, the hole you cut is resealed, and your ceiling is reinforced to extend the time for the fire to spread! In addition, this fire-rated LED downlight is suitable for 30, 60, and 90-minute ceilings and all joist types, including I-joist and web-joist for 30 minutes of protection. Not many downlights can adapt with these joists, so having this fitting gives you confidence that your home is fully fire-protected!