LED Tape, IP65 High Power 15w P/M Warm White

When it comes to energy efficiency, LED lighting is unrivalled. It can convert most of the electricity it consumes into lights with very minimal going to waste. Because of this, LED lighting solutions do not require much power to create outstanding luminance.

Designed using that same technology, this LED strip light only needs 15w of power per metre to produce a whooping 905 lumens maximum brightness with a wide 120-degree beam angle. Also, this strip light can last for 50,000 hours which is ten times longer than a regular incandescent bulb! If you swap out your traditional light fixtures with these strip lights, you’ll be able to enjoy that exquisite light quality and lower your maintenance and electrical expenses!

This is a 24v DC LED strip light, meaning you need an LED driver to make it work. It’s not like those mains-powered lighting fixtures that can be wired directly to the mains circuit. 

To know the appropriate LED driver for your strip light, you must multiply the total length of the strip light you’ll use by its wattage per metre. So, if you’ll use ten metres of LED strip and it’s 15w per metre, multiply the two. Once you get the answer, look for the LED driver that’s equivalent to the strip light’s requirement or more than that. Never get an LED driver with a lower load than what your LED strips need.

We offer a free bespoke cutting service when you purchase this LED strip light, so you don’t have to pay more than you need! Let us know the lengths you require, and we’ll deliver them as you requested! Just note that this LED strip light is cuttable by 100mm increments. When you place your orders, ensure that it’s rounded off to the nearest 100mm.

On top of the free cutting service, we’ll also solder a 1-metre cable at the end of the strip light, so when it arrives, you can immediately proceed to installation. You don’t have to measure, cut and solder anymore! If you have a more specific and detailed request for your LED strip lights, please call us at 0333 443 2465 so we can assist you accordingly.

There are many ways to operate this LED strip light, allowing you to customise the controls to suit your preferences. You can use it with a remote control, an LED-compatible traditional wall dimmer, or smart speakers like Alexa or Google Home. You only need to pair the controls with the appropriate LED driver!

If you don’t want to dim your strip lights or you will couple it with a remote control, use a standard LED driver. Alternatively, if you’re going to use it with a standard wall dimmer, pair it with a dimmable LED driver. Just ensure that the wall dimmer you’re using is LED-compatible because it will flicker or not dim if it’s not.

If you are searching for a lighting solution that you can freely use everywhere in your home (including areas frequented by water), check out this LED strip light! It is IP65 rated, which means it is water-resistant. You can use it in your living room, bedroom, dining room, kitchen, storage room, hallway, garage, and bathroom (zone 1). Even if splashes or jets of water come into contact with these LED strips, they will not malfunction or short-circuit!

Although this LED strip light is IP65 rated, you cannot submerge it underwater. If that is the application you are after, you have to find a strip light with an even higher IP rating.

This LED strip light can produce a warm white colour temperature. Unlike natural white, that’s clear and resembles a cloudless sunny day and cool white that has a crisp bluish tone, warm white light has a yellowish shade. It’s suitable for ambient lighting because its warm glow can create a serene and cosy atmosphere (opposite to cool white and natural white, which is typically used for task lighting).

Normally, this colour temperature is seen in rooms where you relax, like the bedroom or living room. It’s also used as accent lighting to bring a bit of warmth to spaces that prioritise function and efficiency, like the kitchen and home office.